Guidelines for Ensuring Correct Placement of Your Gas Storage Water Heater

9 March 2022
 Categories: , Blog


While there are many different types of water heaters you can use in your home, a storage water heater is one of the most common among homeowners. The widespread use of this hot water system can be attributed mainly to the fact that it can be run on any common type of fuel found in homes. 

If your home is connected to a gas supply, you can arrange a gas water heater installation on the property. The safe and economical use of this appliance will depend on where you place the main hot water cylinder.

These key rules must be observed when installing your gas water heater's main unit.

Provide good airflow

A gas water heater requires enough ventilation to run properly. Adequate ventilation facilitates proper combustion of the fuel, minimising the volume of exhaust gases produced. 

Avoid placing your main unit in an enclosed or confined space to reduce and potentially eliminate health and safety hazards, including carbon monoxide poisoning, fire and even explosions. If these hazards aren't managed effectively, they can cause property damage, serious bodily injury, chronic respiratory illnesses and even death by asphyxiation.

Choose a location indoors that will provide as much air as your hot water unit requires to efficiently burn gas while allowing for the effective release of any exhaust gases to the outside environment.

Ensure centralised fixture placement

If you want to ensure efficient use of your gas water heating system, make sure the main heater unit's location is practical for your hot water piping and fixtures. If the heater location is too far inside the building, lots of heat may be lost while hot water is travelling in the pipes, resulting in the water at the taps not being hot enough.

To prevent this from happening, make sure your hot water unit is located in a spot that's as close as practical to the piping system connected to it.

Provide adequate clearances for servicing

Gas water heaters are mechanical systems that require regular maintenance and will need to be repaired when problems arise. When picking a location for your gas water heater, make sure you pick a spot that provides enough clearance for water heater maintenance and repair crews to work with ease.

Gas water heaters are complex pieces of plumbing equipment that require technical knowledge to install correctly. To ensure proper placement and installation of your gas hot water unit, hire a qualified hot water installer.

Contact a hot water installation service near you to learn more.


Share